![]() ![]() Then, wash in soapy water to remove hand oils and polish, and then dip again in LOS. Brush or selectively remove color from portions of the piece with a polishing cloth. Use any LOS recipe to develop one or two shades past gold or light brown, stopping with a cold-water bath. This is a soft and subtle patina that can have a sophisticated look! 4. More brushing will lighten the color, and a stiff brush will be more aggressive than a soft one. Use a steel or brass brush and a bit of hand soap to scratch brush the surface for a steely effect. Progress through coloring a piece until you reach a gray or blue-gray. Put the piece in the tumbler, add 1-2 tablespoons of hand soap or the recommended amount of a burnishing solution, and then add water to about an inch above the shot. After applying the patina, you may choose to remove or not remove highlights with a polishing cloth. ![]() This method will take the “Traditional antiqued” method to the next level, coloring the metal a reflective, deep gray-to-black similar to the mineral hematite. Non abrasive hand soap or burnishing solution. ![]() See the drama and depth that you have created! 2. After a final soapy rinse, dry the piece and rub “highlights” off with a polishing cloth. For faster results, work with hotter temperatures and longer soaking, and build color gradually versus doing it in one big jump. Use the LOS to patina the piece to a dark black. ![]() Scratch brush a piece and burnish it or tumble for 45 minutes or more to a mirror finish. Traditional Antiquing: Black crevices, bright highlights) Additional materials or tools are listed. The following techniques begin with the basic process of using Liver of Sulfur. Here are five additional Patina finishes that you can achieve with a little experimentation. Squares are 2″ x 2″ and sold in packs of 5. A handy, economical polisher that is truly amazing. They are made of thin, tight-bond foam with permanently bonded micro-abrasives. 303 lbs/in³).These convenient sized Ultra-Polish Pads are great for removing tarnish, highlighting when using liver of sulfur or silver black, or polishing to a high luster, fast and easy. Silver has a density of 10.5 g/cm³ (.379 lbs/in³) and nickel silver 8.4 g/cm³ (. Silver, or one of its alloys, are bright and shiny.271 lbs/in³), wrought iron shares the same density as steel at 7.8 g/cm³ (.282 lbs/in³), and stainless steel of 7.9 g/cm³ (.285 lbs/in³). Iron, or one of its alloys, which are relatively lustrous and gray in hue.Deoxidized copper has a density of 8.9 g/cm³ (.322 lbs/in³), copper nickel 8.8 g/cm³ (.318 lbs/in³), navy brass 8.6 g/cm³ (.311 lbs/in³), and silicon bronze of 8.7 g/cm³ (.314 lbs/in³). Copper, or one of its alloys, which are usually reddish in color.It is a light, common metal that shares a density of 2.7 g/cm³ (. Aluminum, or one of its alloys, which are often silvery-white.Calculate the density of your metal to help determine if it is one of the following common metals/alloys: Each one has unique properties, which means some chemicals will work and others won't. Some metals are made up of a single component, like gold and copper, but others are combinations, called alloys, like brass and steel. ![]()
0 Comments
Leave a Reply. |